In addition to the excellent quality of bearings, they are also very fine parts, both high-functioning bearings, and if they are not used properly in the process, they will not only fail to achieve the expected function, but also easily damage the bearings.

Bearing use matters:

One, the use of the device should be really careful not to promise strong stamping, not to use the pendant direct knocking bearings, not through the dynamic body transfer pressure.

Second, the use of suitable and accurate device things as far as possible to use special things, strongly avoid the use of cloth and short fiber and other things.

Third, try to adhere to the bearing and its nearby environment cleaning even if the naked eye can not see the laughing dust into the bearing, will also increase the bearing wear, oscillation and noise.

Small amateur to see the doorway, the industry is how to improve the bearing corrosion resistance?

Fourth, to avoid bearing corrosion directly by hand to pick up the bearing, to wash the hands of the liquid in full, and coated with excellent mineral oil before operation, in the dry season and summer especially to pay attention to prevent rust. Under certain special operating conditions, bearings can achieve a life expectancy that is better than conventional calculations, especially under light loads. These special operating conditions are when the moving surfaces (tracks and moving parts) are effectively separated by a smooth oil film and the potential for surface damage caused by contaminants is restrained. In fact, under ideal conditions, the so-called long bearing life is possible.

Of course bearing use process, maintenance work is also essential, if, bearing has been working without good maintenance work, bearing use of water-soluble cutting fluid, it is likely to return to lead to water corrosion of metal appearance, thus causing bearing surface smooth poor, and then lead to machine tools, machinery improper operation, resulting in the harm is not small, therefore, for bearing maintenance work is inevitable.

Share bearing use maintenance steps:

1、Keep the bearings lubricated and clean

Bearing inspection before, should first clean the surface of the bearing, and then remove the parts of the bearing. Pay special attention to the fact that the oil seal is a very fragile part, so do not use excessive force in the inspection and dismantling of the bearing to avoid damaging the parts of the bearing. If the oil seal in the inspection of the bearing and its surrounding parts has shown symptoms of bad, please carry out replacement to avoid bad oil seal will lead to bearing damage.

2. Ensure the quality of the bearing lubricant

Many later find that the bearing life is too short, in addition to other factors, normal, but do not know the quality of the lubricant also directly affected. Check the bearing lubricant: lubricant in a small friction between two fingers, if there are any contaminants, can feel it; or on the back of the hand, apply a thin layer of oil, and then seal the light check. Then replace the lubricant of the bearing.

3、The working environment of the bearing

Check the bearing, do not let it be exposed to environmental pollutants or moisture. If the previous two points should be taken plastic or similar material paper covering machine. The working environment of the bearing is also important, many machinery in the bearing is because the working environment is not enough, resulting in the early end of the bearing's life.

4、Bearing seal

The purpose of the bearing seal: to prevent dust, water and impurities into the bearing, but also to prevent the loss of lubricant. Good sealing can ensure the normal operation of the machine, reduce noise and extend the service life of the parts.